It is applicable on all types of mineral based and absorbing surfaces; such as, gross concrete, plaster, brick, compressed brick, travertine, natural stone, mosaic, gas concrete, tile, etc. It is only inapplicable on non absorbing surfaces such as marble, granite, glass, metal, plastic, and on horizontal absorbing surfaces.
WATER-SEAL is used for the protection of the exterior & interior walls of buildings from the effects of rain & water. The purposes of using WATER-SEAL can be listed as follows:
- Prevention of the formation of dirt, blackening and deformations of color due to rain,
- Protection against the damages of frost and the vomiting of salt
- Prevention of moss and fungi.
Preparation of the Surfaces: The surface on which the product shall be applied must be dry or slightly moist and must be cleansed from all types of soil, grease, dust and mud. The layers that will reduce the absorbing quality of the surface must be cleansed. There should be no cracks wider than 0.4 mm on the surface where the product will be applied and the existing cracks must be repaired and eliminated.
Application: Apply the product downwards from up, with a brush or through spraying. Do not apply the product on wet surfaces and make sure that the wet surfaces are dried prior to application. Do not use flammable substances during application and ensure adequate ventilation if the application area is not adequately ventilated. Avoid contacting the product with the eye and the skin, and use protective gloves and glasses during application.
PACKAGING: 5 liters
STORAGE: 2months in dry and cool place.
HEALTHE & SAFETY: Health and Safety: For full information on
Health and Safety matters regarding this product the relevant Health and Safety Data Sheet should be consulted.
STATEMENT OF RESPONSIBILITY
The technical information and application advice given in this Chemiprotect Engineer’s publication are based on the present state of our best scientific and practical knowledge. As the information herein is of a general nature, no assumption can be made as to a product's suitability for a particular use or application and no warranty as to its accuracy, reliability or completeness either expressed or implied is given other than those required by law. The user is responsible for checking the suitability Of products for their intended use.